On the Transport tab, pick up UDP destination (5000) port as AIROPEEK, and click OK. Right-click any frame, and choose Decode as. Remember the raw-pcap ID so that you can stop the remote packet capture.ģ) You should be seeing some traffic arriving at your Wireshark. Note: 5000 is the port you chose in step 1, and '1' is the Airopeek format.

Choose Airopeek format for the remote packet capture. Click Start.Ģ) On the controller, start the raw packet capture from WebUI or CLI. Apply the capture filter as udp port 5000 or whatever port you want. Choose the wired port interface (en0 on Mac OSX, or eth0 on Linux). To configure the Wireshark for remote packet capture, follow these steps:ġ) Start Wireshark as usual.

Product and Software : This article applies to all Aruba controllers and ArubaOS versions. To check if promiscuous mode is enabled, click Capture > Options and verify the “Enable promiscuous mode on all interfaces” checkbox is activated at the bottom of this window.Question: How do I configure the Wireshark for remote packet capture (on Windows, Mac OSX, and Linux)? If you have promiscuous mode enabled-it’s enabled by default-you’ll also see all the other packets on the network instead of only packets addressed to your network adapter. Wireshark captures each packet sent to or from your system. You can configure advanced features by clicking Capture > Options, but this isn’t necessary for now.Īs soon as you click the interface’s name, you’ll see the packets start to appear in real time. For example, if you want to capture traffic on your wireless network, click your wireless interface. Capturing PacketsĪfter downloading and installing Wireshark, you can launch it and double-click the name of a network interface under Capture to start capturing packets on that interface.

Don’t use this tool at work unless you have permission. Just a quick warning: Many organizations don’t allow Wireshark and similar tools on their networks.

Run wireshark pcap